Description
Estorex EP10 is a low viscosity, two-part solvent free epoxy resin compound based injection grouting system. It has high penetrability to the concrete surfaces, and will cure in crack and cavities.
Estorex EP10 is packed in 5 kg set
Coverage Estorex1litre pack will fillll acavity of 25mm deep with 3 mm wide for a length of approximately 13 m.
Estorex EP10 should be stored on pallets in dry conditions. Under these conditions, the product will have a shelf life of 12 months. if stored in extreme heat locations the shelf life may be reduced.
Application Instruction
Horizontal Application
Preparation
Form a V-groove along the crack lines before filling with Estorex EP10. For suspended slabs, seal the underside of the crack with Estobond EC to prevent sealer leakage through the slab.
Mixing
Mix Estorex EP10 Part A and Part B in a 2:1 ratio in a clean vessel until uniform. Thorough mixing is essential for product integrity; follow Estop's technical guide for best results.
Application
Carefully pour the mixed Estorex EP10 into the cracklines or pre-formed V-groove, allowing it to fill completely. Ensure the cracklines or V-groove are clean and free from loose particles, debris, oil, and grease.
Vertical Application
Preparation
Injection nipples shall be installed along the crack lines with Estobond EC. Seal the expose crack lines with Estobond EC. The injection nipples shall be placed 200-400 mm apart, depending upon the depth of crack. The deeper the crack that form, the closer the injection nipples shallbe.
Application
For horizontal application, thoroughly mix components. Inject the mixed material using a grease gun or paint pressure pot, starting from the bottom-most nipple and continuing until it exits the upper nipple. Remove and plug the nipples with appropriate tools afterward.
Reviews
There are no reviews yet.